Mercedes-Benz EQB 2022 Operator's Manual page 356

Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
finger-tight.
Unscrew and remove the centring pin.
#
Tighten the last wheel bolt until it is finger-
#
tight.
Lower the vehicle ( page 353).
/
#
Lowering the vehicle after a wheel change
Requirements
The new wheel has been fitted (
R
To lower the vehicle: place the ratchet onto
#
the hexagon nut of the jack so that the letters
"AB" are visible and turn anti-clockwise.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
page 352).
/
an initial maximum force of 80 Nm.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
the specified tightening torque of 150 Nm.
& WARNING Risk of accident due to incor-
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed torque.
Ensure that the wheel bolts or wheel
#
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the vehi-
#
cle. Contact a qualified specialist work-
shop and have the tightening torque
checked immediately.
Check the tyre pressure of the newly fitted
#
wheel and adjust it if necessary.
%
The following does not apply if the new wheel
1 to 5 with
is an emergency spare wheel.
Vehicles with a tyre pressure monitoring sys-
#
tem: restart the tyre pressure monitoring sys-
1 to 5 with
tem (
/
Wheels and tyres 353
page 344).