Mercedes-Benz EQB 2022 Operator's Manual page 146

Switching on high beam
Turn the light switch to the L or Ã
#
position.
Push the combination switch in the direction
#
of arrow 1.
When high beam is activated, the indicator
lamp for low beam L will be deactivated
and replaced by the indicator lamp for high
beam K.
Switching off high beam
Push the combination switch in the direction
#
1
of arrow or pull it in the direction of arrow
3.
Headlamp flashing
Pull the combination switch in the direction of
#
arrow 3.
Turn signal light
To indicate briefly: push the combination
#
switch briefly to the point of resistance in the
direction of arrow 2 or 4.
The corresponding turn signal light will flash
three times.
To indicate permanently: push the combina-
#
tion switch beyond the point of resistance in
the direction of arrow 2 or 4.
Activating/deactivating the hazard warning lights
Press button 1.
#
Light and sight 143
The hazard warning lights will switch on automati-
cally if:
the airbag has been deployed.
R
the vehicle is braked heavily from a speed of
R
more than 70 km/h to a standstill.
When you pull away again, the hazard warning
light system will switch off automatically at
approximately 10 km/h. You can also switch off
the hazard warning light system using button 1.
Setting the exterior lighting switch-off delay time
Multimedia system:
© Settings Lights
4 5 5
Ext. light. del. sw. off
5
Set the switch-off delay time.
#
When the vehicle's engine is switched off, the
exterior lighting will be activated for the set
time.