Table of Contents
Advertisement
Rev A: May 2010
4. Site Preparation
Before proceeding with the unpacking and installation instructions in the following section(s)
make sure the work site is prepared and ready to install the Pro-Wedge 3XL. You should have
an adequate power source capable of provided clean Alternating Current (AC) power at 220-240
Volts at the rated current. Refer to the welder serial plate affixed to the inside side of the Side
Frame near the Upper Nip Arm for the voltage and current requirements of your welder. The
install area should be clean, dry and free of debris and provide adequate working area to allow
efficient and effective use of the welder.
Follow the detailed unpacking and installation instructions carefully.
5. Unpacking & Installation Instructions
This section contains instructions for the unpacking, placement and installation of the Pro-
Wedge 3XL. Carefully review the following information, sub-sections and each procedure
before beginning unpacking and installation of the welder.
The Pro-Wedge 3XL comes complete in a sturdy, reusable portable shipping/storage case. The
custom foam inserts protect the welder from damage during shipping and storage and should
always be left inside the case at all times. When the welder is out of the case make sure to keep
the lid closed to avoid dirt, dust, debris and/or water from getting inside. The welder must be
removed from the case and placed onto the work site for use. When not in use the Pro-Wedge
3XL should always be stored in the shipping/storage case to protect it from the elements and
potential damage.
Note: The welder illustrated in this manual shows ALL available features for the Pro-
Wedge 3XL, therefore, your welder may vary slightly in appearance from that depicted.
Pro-Wedge 3XL Manual
Pro-Wedge 3XL Operator's Manual
Page 4
Advertisement
Table of Contents
