Demtech Pro-Wedge 3XL Operator's Manual page 18

Rev A: May 2010
c. Place two of the 1/2" X 6" material pieces, each folded in half, between the Nip Rollers
(1) (see Figure 3). This procedure simulates two layers of material between the Rollers.
Be sure these pieces do not extend past the Nip Rollers into the welder. Rotate the Nip
Pressure Cam (2) (see Figure 3) to the corresponding mil thickness position indicated on
the side of the Pressure Cam by rotating the Nip Pressure Cam Lever (3) (see Figure 3)
clockwise.
(3)
(2)
(1)
Figure 3
Pro-Wedge 3XL Manual Pro-Wedge 3XL Operator's Manual Page 12