Demtech Pro-Wedge 3XL Operator's Manual page 22

Rev A: May 2010
(2)
(2)
(3)
(5)
(5)
Figure 6
c. Once adjusted the Lock-In Disc must be tightened in place. Firmly hold down the Lock-
In Disc, pull out the Wedge Engagement Handle Lock-In Plunger and rotate the Handle
to a central position between the two Hold-Down Screws. Do not allow the Lock-In Disc
to move during this procedure. Firmly tighten both Hold-Down Screws then rotate the
Wedge Engagement Handle counter-clockwise until the Lock-In Plunger drops into the
Lock-In Hole. Verify that the Wedge engaged position did not change during this
procedure.
Pro-Wedge 3XL Manual Pro-Wedge 3XL Operator's Manual Page 16