Table of Contents
Advertisement
iSitePower-M (MAP05A1, MAB05B1)
User Manual
● To prevent dust inhalation or contact with eyes, wear safety goggles and an
● Wipe away any dust in or around the holes and measure the hole spacing. If
● Level the head of the expansion sleeve with the concrete wall or ground after
● Loosen the nut, spring washer, and flat washer of the expansion bolt at the
----End
6.2.2 Wall Mounting
Procedure
Step 1 Mark the mounting holes for the wall-mounting bracket and battery modules.
Figure 6-8 Standard mounting holes
Step 2 Drill holes and install expansion bolts.
When drilling holes, avoid the water pipes and power cables buried in the wall.
Issue 02 (2021-12-30)
NO TICE
anti-dust mask when drilling holes.
the holes are inaccurately positioned, drill holes again.
removing the nut, spring washer, and flat washer. Otherwise, the mounting
bracket will not be securely installed.
bottom.
D ANGER
Copyright © Huawei Digital Power Technologies Co., Ltd.
6 System Installation
48
Advertisement
Table of Contents
