Table of Contents
Advertisement
iSitePower-M (MAP05A1, MAB05B1)
User Manual
Table 4-2 Terminals on the panel
Pin
1
2
3
4
5
6
7
9
10
8
Wireless Backhaul Module Port
After a wireless backhaul module is inserted into the port, alarms and signals can
be reported to the NetEco in wireless mode.
WiFi Switch
The power module has a built-in WiFi module. You can press the WiFi switch to
enable or disable WiFi and reset the passwords of WiFi and the monitoring unit.
●
●
Issue 02 (2021-12-30)
Signal
RS485A
RS485B
NC
COM
NO
DIN1+
DIN1-
DIN2+
DIN2-
GND
Enable/Disable WiFi: Hold down the WiFi switch for at least 10s to enable or
disable WiFi. The WiFi function is disabled by default.
WiFi password and monitoring unit password reset: Press the WiFi switch for
three consecutive times within 10s. Wait for more than 1s and press the
switch again to reset the WiFi password and monitoring unit password.
Copyright © Huawei Digital Power Technologies Co., Ltd.
Description
RS485 signal
Dry contact
output NC
terminal
Dry contact
output common
terminal
Dry contact
output NO
terminal
Dry contact input
DIN 1
Dry contact input
DIN 2
-
4 Components
Function
Reserved ports
Connect to a genset
and control genset
startup and
shutdown signals.
These ports are
reserved and can
connect to an ATS. In
the grid + genset
scenario, the DIN dry
contacts are used to
detect grid signals.
-
24
Advertisement
Table of Contents
