Control Panel - Supermicro SuperServer SYS-110A-16C-RN10SP User Manual

Control Panel

Item Feature
1 Power button
2 Reset Button
3 Power LED
4 HDD
5 NIC (LAN1) LED Indicates network activity on LAN1 when flashing.
6 NIC (LAN2) LED Indicates network activity on LAN2 when flashing.
7 Information LED
8 Overheat LED
Color, Status
Red, solid
Red, blinking at 1Hz
Red, blinking at 0.25Hz
Red, solid, with Power LED blinking green
Blue and red, blinking at 10 Hz
Blue, solid
Blue, blinking at 1Hz
Blue, blinking at 2Hz
Blue, blinking at 4Hz
Blue, blinking at 10Hz with Power LED blinking green BMC/BIOS firmware is updating
1
2
3
5
7
Figure 1-3. Control Panel
Control Panel Features
Description
The main power switch applies or removes primary power from the power supply
to the server but maintains standby power.
System Reset.
Indicates power is being supplied to the system power supply units. This LED is
illuminated when the system is operating normally.
Indicates activity on the storage drives when flashing.
Alerts operator to several states, as noted in the table below.
If this indicator is continuously on and red, an overheat condition has occurred.
Information LED
Description
An overheat condition has occurred.
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power supply.
Fault detected
Recovery mode
UID has been activated locally to locate the server in a
rack environment.
UID has been activated using the BMC to locate the
server in a rack environment.
BMC is resetting
BMC is setting factory defaults
10
Chapter 1: Introduction
4
6
8