NON-HEATED SURFACE CLEANING SCHEDULE ("D" = Daily / "W" = Weekly / "M" = Monthly)
> This sheet pertains to cleaning the merchandiser in non-heated areas only.
Cleaning
D
Sides / Front /
Toe-Kicks /
Bumpers, Rear
X
Sliding Storage
Doors, etc.
Glass Surfaces
X
Quartz Solid
X
Surface
Stainless Steel
Posts / Glass
Supports /
Removable
X
Holder-
Containers
(At Case Rear)
Under Case
Cleaning
W
M
Wipe off all external surfaces with warm water and mild soap solution and
non-abrasive cloth. Dry with soft cloth or paper towel.
Clean front, side and top glass surfaces with a household or commercial glass
cleaner and a soft cloth or paper towel.
Caution! After removing product, allow stone solid surface to cool before
cleaning. See CLEANING & MAINTENANCE of NATURAL QUARTZ (AND
OTHER STONE) SURFACES section in this operating manual (next page).
General Stainless Steel Surface Cleaning:
Stainless steel requires a specific cleaning procedure to maintain its sheen
and remain rust-free.
Wash with a solution of liquid dishwashing detergent and hot water.
Rinse with hot water from spray bottle. Wipe with clean sponge. This will
remove soap residue that can lodge in stainless steel's microscopic grooves,
causing rust.
Dry with clean, soft cloth or paper towel.
Caution! To prevent rust, you MUST rinse with hot water while wiping with
clean sponge after EACH cleaning.
Caution! Never use scouring powder or steel wool on stainless steel as they
can mar or scratch the surface.
Brightening Stainless Steel Surfaces:
Method 1: Brighten by polishing with a soft cloth or sponge dipped in vinegar
or ammonia.
Method 2: Sprinkle baking soda on sponge and rub gently with soft cloth or
sponge.
Caution! To prevent rust, you MUST rinse with hot water while wiping with
clean sponge after EACH cleaning.
Dry with clean, soft cloth or paper towel.
Removing Streaks or Stains
Remove streaks or stains by dipping soft cloth or sponge in club soda and
rubbing gently over area of concern.
Caution! To prevent rust, you MUST rinse with hot water while wiping with
clean sponge after EACH cleaning.
Dry with clean, soft cloth or paper towel.
Remove front toe-kick (no screw removal required) or rear toe-kick (screw
X
removal required). Use a broom or vacuum to remove dust and dirt. Replace
toe-kick when finished.
Task
28
Need help?
Do you have a question about the grocerant DP8HP60WD.5718B and is the answer not in the manual?