Table of Contents
Advertisement
SPA with HART
alarm
®
December 2022
C.3
Setup
To set up the SPA for communication with the transmitter, set internal jumpers
and dip switches and configure the SPA operating parameters via a menu-driven
selection and calibration procedure.
C.3.1
Jumper and switch settings
If the SPA with HART
transmitter, jumper and switch setting adjustments are not required. However,
you may use the following procedure to verify that the jumper and switch settings
are correct. Adjust or verify jumper and switch settings as follows:
SPA jumper and switch settings are shown in
CAUTION
Equipment damage
Protect the SPA from electrostatic discharge (ESD) to avoid damage to the SPA
electronic circuits.
Procedure
1. Refer to
326
was factory-configured by Emerson for operation with your
®
Figure
C-3. Turn the SPA over and slide the access cover out.
00809-0500-4881
Figure
C-3.
Emerson.com/Rosemount
Manual
Advertisement
Table of Contents
