Update Firmware; Reset To Factory Defaults; Resetting Via Web Interface - Enttec PIXELATOR MINI User Manual

ESP
The information provided is:
Poll packets received

Data packets received

Last IP where ESP packets were received from

Last port data received from


Update Firmware

When selecting the Update Firmware tab, the PIXELATOR MINI will stop outputting and the web interface
boots into the Update Firmware mode. It may take a while depending on the network setting.
This mode will display basic information
regarding the
Firmware Version, Mac Address and IP address
information.
The latest firmware can be downloaded from
www.enttec.com. Use the Browse button to
select an PIXELATOR MINI firmware from your
computer. PIXELATOR MINI firmware files have
a .bin extension.
Next click on the Update Firmware button to
begin updating.
After the update has completed, the web
interface will load the Home tab, where you
can check the update was successful under
Firmware Version. Once the Home tab has
loaded, the PIXELATOR MINI will resume
operation.

Reset to Factory Defaults

The PIXELATOR MINI can be reset by either the web interface or the reset button on the device. It resumes
the device's settings back to factory default, see Out of the Box section for the factory default settings.

Resetting via Web Interface

The reset to defaults command can be found under the Settings tab of the PIXELATOR MINI's local hosted
web interface.
Once the command is pressed, a pop-up would appear as shown in the image below:
Manually refresh the page after resetting to defaults to ensure the webpage information is updated.
11 |
device including current
ID: 5934948
ENTTEC website
Visit the
Document Updated: Dec 2022
PIXELATOR MINI (70067)
for the latest version.
USER MANUAL
