Enwork Expanse Installation Manual page 6

4 — E X T R U S I O N A S S E M B LY
4.1
Extrusion Description
U-Channel
Space
Bottom
4.3
Assemble the C Channels(EAM-1001-xx) into the
outside of the extrusion with the embossed "T"
facing up and the opening of the C facing outside.
Note: Do not tighten the bolts at this time
TI0075 - Expanse Table Installation Instructions
Top
4.2
Place the extrusions in a clear area on a non marring
surface, in an order similar to their completed position.
Note: The Number of extrusions is dependent on table length.
Assemblies with 2 extrusions, assemble
the Left and Right Extrusion
Assemblies with 3 extrusions, skip to
section 5) Table Frame Assembly
Assemblies with 4 extrusions, assembly the Mid Extrusion
4.4
Line up 2 of the threaded holes. Install (2) .25"-20 x
.50". and finger tighten. Repeat for all Extrusion.
Note: Do not tighten the bolts at this time
6