Enwork Stealth Manual
Conference table assembly 3 base configurations
Hide thumbs
Also See for Stealth:
- Installation instructions manual (6 pages) ,
- Installation manual (6 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Enwork Stealth
Summary of Contents for Enwork Stealth
- Page 1 Stealth Conference Table Assembly 3+ Base Configurations Rev 0915...
- Page 2 FIGURE #1 FULL BASE ASSEMBLY TOOLS REQUIRED: FASTENERS INCLUDED IN HARDWARE PACK: #2 PHILLIPS SCREWDRIVER, OR DRIVER BIT WITH POWER TOOL 5/16-18 FLANGE NUTS ATTACHED TO 90° CORNER BRACKET ½” COMBINATION WRENCH #1 SCREW...
- Page 3 TOP SUPPORT EXTRUSION FIGURE #2 - EXTRUSION BEAM DEPENDING UPON BEAM LENGTH THE NUMBER OF TOP SUPPORT EXTRUSIONS WILL VARY. THEY SHOULD BE EVENLY SPACED BETWEEN EXTRUSIONS AND ½ THE DISTANCE FROM THE EXTRUSION TO THE BASE ASSEMBLY...
- Page 4 90° BRACKETS (LEFTHAND & RIGHTHAND ) FIGURE #3 - BASE ASSEMBLY AS SHIPPED FIELD INSTALLED WITH TOP OF BRACKET FLUCS WITH TOP OF ALUMINUM EXTRUSION TOP MOUNTING PLATE (2) PER BASE ASSEMBLY...
- Page 5 PANEL RETAINER PLATE & SCREW LEVELER FIGURE #5 NOTE PANEL RETAINER PLATE, SCREWS AND LEVELERS ARE INSTALLED AT THE FACTORY. LEVELERS SHOULD BE ADJUSTED AS NEED TO LEVEL TABLE BASE ASSEMBLY PRIOR TO INSTALLING TABLE TOP...
- Page 6 FIGURE #6 INSERT EXTRUSION ON TO BOLT PLATE, BOLT PLATE SHOULD SLIDE INTO CHANNEL IN EXTRUSION (SEE FIGURE #7) EXTRUSION CHANNEL FOR BOLT PLATE...
- Page 7 FIGURE #7 REPEAT PROCESS FOR OPPOSITE EXTRUSION, CONTINUE WITH THE OPPOSTE BASE. ONCE THE EXTRUSIONS ARE ATTACHED TO THE TWO BASES MAKE SURE THAT THE TOP SUPPORT EXTRUSIONS (SEE FIGURE #2) ARE LEVEL WITH THE MOUNTING PLATE (SEE FIGURE #3). TIGHTEN ALLFLANGE NUTS SECURELY USING A ½”...
- Page 8 CENTER PANEL BASE OUTSIDE VIEW NOTE: SEAM BETWEEN CROSS BEAMS SHOULD MEET IN CENTER OF PANEL BASE RIGHT ANGLE BRACKETS LOCATED AS SHOWN BELOW...
- Page 9 NOTE HOW RIGHT ANGLE BRACKETS SPLIT CONNECTION AS SHOWN...
- Page 10 RIGHT ANGLE CONNECTOR EXTRUSIONS ARE SHOWN IN TRANSPARENT MODE TO SEE RIGHT ANGLE CONNECTOR IN POSITION. PLACE THIS INTO FRONT SLOT BOTH SIDES PRIOR TO CONNECTING CENTER PANEL BASE.
- Page 11 MOUNTING PLATES INSIDE VIEW SHOWING MOUNTING PLATES POSITIONED IN EXTRUSION CHANNELS...
- Page 12 POSITION CONNECTOR TOP PLATE OVER MOUNTING PLATE BOLTS AS SHOWN SECURE WITH (2) 5/16-18 SARRATED HEAD HEX NUTS...
- Page 13 INSTALL CENTER PANEL “T” CONNECTOR SECURE WITH (4) 5/16-18 SARRATED HEAD HEX NUTS REPEAT PROCESS FOR OPPOSITE CROSS MEMBERS.
Need help?
Do you have a question about the Stealth and is the answer not in the manual?
Questions and answers