Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Enwork Concurrence Conference Table
Summary of Contents for Enwork Concurrence Conference Table
- Page 1 Concurrence Conference Table Installation Instructions Rev 0315...
- Page 2 P a g e...
- Page 3 P a g e STEP 1 ATTACHING HORIZONTAL BEAMS USE PHILLIPS HEAD SCREWDRIVER TO INSTALL QTY:2, 1/4-“-20X ½” SCREWS PER COLUMN DO NOT TIGHTEN YET THE BEAM SITS INSIDE OF THIS TAB AND RESTS ON THE TOP OF COLUMN. BEAM MUST REST ON TOP OF COLUMN FOR PROPER FIT.
- Page 4 P a g e STEP 1 CONT. ATTACHING HORIZONTAL BEAMS REPEAT THE PREVIOUS STEPS TO ATTACH ALL PANEL BASES TO HORIZONTAL BEAMS ENSURE THAT PANEL BASES ARE SQUARE TO HORIZONTAL BEAM AND TIGHTEN INSTALLED FASTENERS SECURELY...
- Page 5 P a g e STEP 2 SECURING WORK SURFACE BRACKETS WORK SURFACE ATTACHMENT BRACKET USE PHILLIPS HEAD SCREWDRIVER TO INSTALL AND TIGHTEN QTY:2, ¼”-20 X 3/4” FLAT HEAD SCREWS PER COLUMN REPEAT FOR ALL WORK SURFACE ATTACHMENT BRACKETS...
- Page 6 P a g e STEP 3 ATTACHING THE WORK SURFACE INSERT BISCUTS INTO SLOT CUTS ON SEAM & BRING BOTH SURFACES TOGETHER VIEW OF UNDERSIDE OF WORK SURFACE INSERT CONNECTOR BUT DO NOT TIGHTEN ALL THE WAY. ADJUST THE WORKSURFACES SO THAT THE EDGES ARE ALIGNED.
- Page 7 P a g e STEP 3 CONT. ATTACHING THE WORK SURFACE WORK SURFACE TRANSPARENT FOR CLARITY CENTER THE WORK SURFACE ON THE TABLE BASE ASSEMBLY & INSTALL QTY: 4 WOOD SCREWS PER WORK SURFACE ATTACHMENT BRACKET WORK SURFACE ATTACHMENT BRACKET...
Need help?
Do you have a question about the Concurrence Conference Table and is the answer not in the manual?
Questions and answers