Table of Contents
Advertisement
Calibrating Miter
Gauge
The miter gauge adjusts between 60° left and
60° right. The angle indicator should indicate the
angle of the miter body in relation to the blade, but
it can be calibrated if these values do not match.
Tools Needed
Phillips Head Screwdriver #2 ............................ 1
90° Square ........................................................ 1
To calibrate miter gauge:
1.
DISCONNECT MACHINE FROM POWER!
2.
Slide miter gauge into T-slot on table.
3.
Loosen miter handle and pull stop pin knob
(see Figure 135).
Stop Pin
Knob
Figure 135. Miter gauge adjustment
components.
Model G0962A40 (Mfd. Since 07/22)
Qty
Miter Handle
4.
Place square evenly against miter body and
blade, as shown in Figure 136.
— If angle indicator does point to 90° when
miter body is square to blade, no adjust-
ment is necessary.
— If angle indicator does not point to 90°
when miter body is square to blade, pro-
ceed to Step 5.
Square
Miter Gauge
Figure 136. Miter body square to blade.
5.
Loosen Phillips head screw shown in
Figure 137, adjust indicator so it points to
90°, then tighten screw to secure.
Indicator
Figure 137. Location of angle indicator and
Phillips head screw.
Blade
-77-
Advertisement
Table of Contents
