Grizzly G0962A40 Owner's Manual page 70

6. Tilt blade to about 5° so there is room for stop
nuts to move.
7. Loosen stop nuts and adjust according to
how far off blade was from 90°. Recheck
blade and repeat adjustment as necessary
until blade stops at 90°, then tighten stop nuts
against each other and replace motor cover.
Note: Turning stop nuts clockwise adjusts
blade further to right; turning them counter-
clockwise adjusts blade to left.
Setting 45° Stop
1. DISCONNECT MACHINE FROM POWER!
2. Raise blade as high as it will go, then tilt it
towards 45° until it stops and cannot be tilted
any more.
3. Place a 45° square against table and blade
so it contacts blade evenly from bottom to top
(see Figure 114). Make sure blade teeth do
not obstruct placement of square.
45° Square
Figure 114. Checking blade at 45°.
-68-
Blade
Table
— If blade is 45° to table, then no adjust-
ments need to be made. Proceed to
Step 8.
— If blade is not 45° to table, you will need
to adjust 45° limiting block. Proceed to
Step 4.
4.
Remove rear access panel.
5.
Loosen (2) M5-.8 x 10 cap screws in 45° limit-
ing block (see Figure 115).
45° Limiting
Block
Figure 115. Location of 45° limiting block.
6.
Tilt blade away from 45° by about 5°, so
there is room for limiting block to move.
7.
Adjust 45° limiting block according to how far
off blade was from 45°, then recheck blade
and repeat adjustment as necessary until
blade stops at 45°, then tighten cap screws
and replace rear access panel.
8.
Make sure tilt indicator arrow points to 45°
mark on scale. If it does not, adjust indicator
arrow as described on Page 67.
Model G0962A40 (Mfd. Since 07/22)
x 2