Table of Contents
Advertisement
Riving Knife
review this section, even if your saw riving knife
came pre-installed. you must install the riving
knife or the splitter and blade guard before operat-
ing the table saw.
components and hardware Needed:
riving Knife ....................................................... 1
To install the riving knife:
1.
remove the table insert, blade guard, and
splitter—if previously installed.
2.
loosen the hex bolt (figure 29), insert the
riving knife into the bracket slot, and tighten
the hex bolt to secure the riving knife.
3.
reinstall and secure the table insert.
riving Knife
figure 29. riving knife installed.
On/Off Switch
components and hardware Needed:
safety pin .......................................................... 1
Flange Bolts m8-1.25 x 25................................. 2
To install the switch:
1.
Fasten the switch to the left end of the front
rail with two flange bolts, and install the anti-
start safety pin as shown in figure 30.
model g0605X/g0606X (mfg. since 11/06)
Qty
Bracket
hex Bolt
Qty
Flange Bolt
anti-start
safety pin
figure 30. switch installed.
Miter Gauge
components and hardware Needed:
miter gauge ....................................................... 1
miter gauge handle .......................................... 1
Flat Washer 8mm .............................................. 1
To install the miter gauge:
1.
install the miter gauge handle and 8mm flat
washer onto the miter gauge as shown in
figure 31.
handle
Washer
figure 31. miter gauge installed.
2.
slide the miter gauge into the miter gauge
slot to the left of the blade; or store it tempo-
rarily on the brackets near the blade angle
handwheel.
stop paddle
Qty
-25-
Advertisement
Table of Contents
