Table of Contents
Advertisement
Items Needed in Step 2
Description
HDZ (Z-Axis Assembly)
HDZ Hardware: M6×20mm Socket Head Cap Screws
X-Axis Stepper Motor
X-Motor Hardware: M5×10mm Socket Head Cap Screws
12
2.1 Install the HDZ
1.
Open the HDZ box and remove the assembled
Qty
HDZ (Z-Axis Assembly), HDZ hardware, X-Axis
1
stepper motor, X-Axis stepper motor hardware.
4
2. Set the Y-Left and Y-Right end caps and
hardware aside. You will not need them until
1
STEP 4 and STEP 5.
4
3. Align the HDZ with the two short locating pins
on the front of the X-Axis carrier plate and push
it onto the carrier plate. See Fig . 2-1.
a. Z-Axis stepper motor on top.
Figure 2-1
my.carbide3d.com
support@carbide3d.com
b. The HDZ slides onto the two locating pins.
Note that it may not slide all the way
onto the pins until the four SHCS are fully
tightened.
4. Hold the HDZ in place as you loosely insert four
(4) M6×20mm SHCS. See Fig . 2-1.
NOTE: Do not let go of the HDZ until at least two of
the SHCS are installed.
5. Use a 5mm hex key to fully tighten the SHCS
and secure the HDZ to the carrier plate.
13
Advertisement
Table of Contents
