Table of Contents
Advertisement
4.6 Install Y-Right End Cap
1.
Gather the Y-Right end cap and hardware, one
M6×30mm and one M6×12mm SHCS.
2. Make sure the wiring at Y-Right is tucked into the
cavity in the extrusion.
3. Place the right end cap on the Y-Right end of the
gantry extrusion. See Fig . 4-10.
a. The long straight edge goes to the back.
b. Be careful not to pinch the wires behind the
end cap.
4. Use a 5mm hex key to insert one (1) M6×30mm
SHCS through the top screw hole.
Figure 4-10
26
5. Locate the green and yellow grounding wire
exiting the wiring harness at the head.
6. Place the loop at the end of the grounding wire
onto the end of the M6×12mm SHCS.
7. Use a 5mm hex key to insert the M6×12mm
SHCS through the bottom screw hole in the end
cap. See Figs . 4-10 and Fig . 4-12.
my.carbide3d.com
M6×12 SHCS
Grounding Wire
Figure 4-12
Z-Limit Switch
Z-Motor
Figure 4-11
support@carbide3d.com
4.7 Connect Z-Axis Cables
1.
At the back of the HDZ, connect the Z-Axis
motor and Z-Axis limit switch cables. See
Fig . 4-11.
a. Z-motor connectors are 4-pin, dual row.
b. Z-limit switch connectors are 3-pin, single
row.
27
Advertisement
Table of Contents
