Table of Contents
Advertisement
4.10 Install Grounding Block
1.
Locate the grounding block and its hardware in
the Grounding Block bag.
2. Position the grounding block on the inside of the
Y-Right assembly, at the rear. See Fig . 4-15.
a. Six non-threaded holes face the rear.
b. Two threaded holes face up.
3. Use a 3mm hex key and two (2) M4×30mm
BHCS to attach the grounding block to the
inside of the Y-Right assembly. See Fig . 4-15.
Figure 4-15
30
4. Locate the green and yellow cable with the
banana plug exiting the wiring harness.
5. Insert the banana plug into any of the six
non-threaded holes on the rear face of the
grounding block.
my.carbide3d.com
4.11 Connect Front Plate
Extension
1.
Locate the end of the front plate extension
(4-pin, single-row) at the back of the machine at
Y-Right.
2. Connect the extension cable to the 4-pin, single
row connector exiting the wiring harness.
a. Align the locking tabs for proper orientation.
support@carbide3d.com
31
Advertisement
Table of Contents
