Table of Contents
Advertisement
6.2 Install the BitSetter
1.
Locate the BitSetter box in the S5 Electronics
box.
2. Slide the two (2) Teez Nuts into the T-track
slot integrated into the Y-Right assembly. See
Fig . 6-2.
3. Position the BitSetter over the Teez Nuts.
a. The 3-pin port on the base faces to the right.
4. Use a 5mm hex key to loosely insert two
(2) M6×30mm SHCS through the top of the
BitSetter and into the Teez Nuts. See Fig . 6-3.
Figure 6-2
38
5. Slide the BitSetter close to the front edge of the
baseframe. Fully tighten the SHCS.
6. Plug the short 3-pin BitSetter extension cable
into the 3-pin port on the inside edge of the
front-right endplate. See Figs . 6-2 and 6-3.
7. Plug the other end of the 3-pin extension cable
into the 3-pin port on the BitSetter. See Fig . 6-3.
my.carbide3d.com
6.3 Tidy Up
1.
Locate the zip ties and self-adhesive cable ties
in the Open Me First box.
2. Use a self adhesive cable tie and a zip tie to tidy
the Y-Left cables at the back of the machine.
3. Readjust the reusable velcro strapping attached
to wiring harness trunk, as needed, to tidy the
wiring harness cables.
Congratulations, the Shapeoko 5 Pro assembly is
complete!
Figure 6-3
support@carbide3d.com
IMPORTANT:
Before homing your machine, you
MUST update your machine configuration settings .
See the Shapeoko 5 Pro Getting Started Guide for
detailed instructions .
39
Advertisement
Table of Contents
