Table of Contents
Advertisement
Items Needed in Step 1
Description
Baseframe Members
Y-Right Assembly
Y-Left Assembly
Y-Axis Assembly Hardware: M6×16mm Button Head Cap Screws
Tool Bag
Cable Track
X-Axis Gantry Assembly
4
1.1 Unpack Box 1
Qty
1.
In Box 1, locate the box labeled Open Me First,
4
remove the tool bag, and set the box aside.
2. Locate the S5 Electronics and HDZ boxes and
1
set them aside.
1
3. Locate the Baseframe box between the two
16
Y-Rails at the bottom of Box 1 and remove it.
4. Open the Baseframe box and remove the four
1
baseframe members.
1
1
Figure 1-1
my.carbide3d.com
support@carbide3d.com
1.2 Position Baseframe
1.
Position the four baseframe members
horizontally across your table about 15.7 inches
apart, center to center. See Figure 1-1.
a. The wire clips face to the right.
2. Open the wire clip on the end of each
baseframe member.
5
Advertisement
Table of Contents
