Connect Y-Left Motor And Limit Cables; Connect Y-Right Motor And Limit Cables - Carbide 3D Shapeoko 5 Pro Assembly Manual

4.8 Connect Y-Left Motor
and Limit Cables
1. Move to back of the machine at Y-Left (right side
of the machine from the back).
2. Locate the two connectors, 4-pin Y-Left-motor
and 3-pin Y-Left-limit switch, exiting from the
Y-Left wire keeper.
3. Connect the Y-Left stepper motor. See Fig . 4-13.
a. YL-motor connectors are 4-pin, dual-row.
b. Align the locking tabs for proper orientation.
Y-Left Limit
Switch
Figure 4-13
28
4. Connect the Y-Left limit switch. See Fig . 4-13.
a. YL-limit switch connectors are 3-pin, single-
row.
b. Align the locking tabs for proper orientation.
Y-Left Motor
my.carbide3d.com
4.9 Connect Y-Right Motor
and Limit Cables
1. Move to the Y-Right side of the machine.
2. Locate the two Y-Right cables (one 4-pin and
one 3-pin) exiting the wiring harness trunk.
3. Connect the Y-Right stepper motor. See
Fig . 4-14.
a. YR-motor connectors are 4-pin, dual-row.
b. Align the locking tabs for proper orientation.
Figure 4-14
support@carbide3d.com
4. Connect the Y-Right limit switch. See Fig . 4-14.
a. YR-limit switch connectors are 3-pin, single-
row.
b. Align the locking tabs for proper orientation
Y-Right Limit
Switch
Y-Right Motor
29