Table of Contents
Advertisement
Items Needed in Step 4
Description
Wiring Harness
Drag Chain Hardware: M3×6mm Socket Head Cap Screws
Front Plate Extension Cable (3-pin Male to 4-pin Male)
Y-Right End Cap
Top End Cap Hardware: M6×30mm Socket Head Cap Screw
Bottom End Cap Hardware: M6×12mm Socket Head Cap Screw
Wire Keeper Hardware: M6×16mm Button Head Cap Screws
Figure 4-1
18
4.1 Install Wiring Harness
Qty
The wiring is pre-made, pre-tested, and is an exact
1
fit for your machine. The wiring harness has several
different branches: Z-Axis, X/Z/LED, front plate, Y-Left,
4
Y-Right, and the controller. See Fig . 4-1.
1
1.
Locate the wiring harness and drag chain
hardware bag in the Wiring Harness box (inside
1
the S5 Electronics box).
1
2. Unroll and lay the wiring harness across the
1
baseframe, from front-to-back.
a. The five connectors and the grounding wire
4
loop go to the front (the head).
b. The wiring harness trunk, the long cable
bundle, goes to the back (the tail).
Figure 4-2
my.carbide3d.com
support@carbide3d.com
3. Lift the drag chain, slide it under the gantry, and
place it on top of the Y-Right assembly.
4. Curl the head of the wiring harness up so that it
rests on the bracket on the back of the Y-Right
carriage plate. See Fig . 4-2.
5. Use a 2.5mm hex key and two (2) M3×6mm
SHCS to secure the drag chain head to the
bracket. Fully tighten. See Fig . 4-2.
M3×6mm SHCS
19
Advertisement
Table of Contents
