Table of Contents
Advertisement
4.5 Attach Cables at Y-Right
NOTE: Connectors are polarized and will only
connect one way. Do not force a connection. Be sure
the connectors are properly oriented with the locking
tabs aligned before plugging them in. See Fig . 4-8.
1.
Move to the Y-Right side of the gantry.
a. Five cables exit the wiring harness head at
Y-Right: LED, X-motor, Z-motor, Z-limit switch,
and X-limit switch.
b. Each cable has a different connector type, so
there is only one match for each connector.
Figure 4-7
24
Figure 4-8
my.carbide3d.com
2. Connect the gantry LED. See Figs . 4-7 and 4-9.
a. LED connectors are 2-pin, dual-row (vertical).
b. The LED cable exits the end of the gantry.
c. Align the locking tabs for proper orientation.
3. Connect the X-Axis stepper motor.
a. X-motor connectors are 4-pin, dual-row.
b. Align the locking tabs for proper orientation.
4. Connect the X-Axis limit switch.
a. X-limit switch connectors are 3-pin, single-
row.
b. Align the locking tabs for proper orientation.
Figure 4-9
support@carbide3d.com
5. Connect the Z-Axis stepper motor.
a. Z-motor connectors are 6-pin, dual-row.
b. Align the locking tabs for proper orientation.
6. Connect the Z-Axis limit switch.
a. Z-limit switch connectors are 4-pin, single-
row.
b. Align the locking tabs for proper orientation.
7. Direct all five wires below the X-Axis motor
mount, then tuck them into the open end of the
gantry extrusion.
25
Advertisement
Table of Contents
