Table of Contents
Advertisement
Items Needed for Step 3
Description
Hybrid Extrusion
M6×10mm Flat Head Screws
MDF Strip
M6×20mm Socket Head Cap Screws
Figure 3-1
16
3.1 Install Extrusions
1.
Locate the aluminum extrusions, MDF strips, and
Qty
the small hardware box inside Box 2. The MDF
strips are nested inside the extrusions.
10
2. Lay the ten (10) aluminum Hybrid Table
80
extrusions across the baseframe, front to back.
3. Use a 4mm hex key and eight (8) M6×10mm FHS
10
to loosely attach each extrusion. See Fig . 3-1.
40
a. Insert screws in order: front, back, center.
4. Fully tighten all screws to secure the extrusions.
NOTE: We do not recommend using power tools
here; the risk of cross-threading is too high.
Figure 3-2
my.carbide3d.com
support@carbide3d.com
3.2 Install MDF Strips
1.
Position the ten (10) MDF strips inside the Hybrid
Table extrusions. See Fig . 3-2.
2. Use a 5mm hex key and four (4) M6×20mm
SHCS to loosely attach each MDF strip.
a. Insert screws in order: front, back, center.
3. Fully tighten all screws to secure the MDF strips.
M6×20mm SHCS
17
Advertisement
Table of Contents
