Table of Contents
Advertisement
Items Needed in Step 6
Description
Controller
Power Pendant
Power Pendant Extension Cable (8-pin Male to 6-pin Male)
USB Cable
3-Prong Controller Power Cable
BitSetter
BitSetter Hardware: M6×30mm (2) and Teez Nuts (2)
BitSetter Extension Cable (3-pin Male to 3-pin Male)
36
6.1 Connect the Controller
Qty
1.
Locate the Controller box, Power Pendant box,
1
and USB cable in the S5 Electronics box.
1
2. Plug the 18-pin motor wiring bundle connector
1
into the larger 18-pin "MOTORS" port on the
controller. See Fig . 6-1.
1
3. Plug the 22-pin limit switch wiring bundle
1
connector into the smaller 22-pin "SWITCHES"
port on the controller. See Fig . 6-1.
1
4
1
Figure 6-1
my.carbide3d.com
support@carbide3d.com
4. Plug the 8-pin end of the power pendant cable
into the port labeled "POWER PENDANT" on the
controller.
5. Plug the 6-pin end of the power pendant cable
into the power pendant.
a. Align the locking tabs for proper orientation.
6. Plug the USB cable into the port labeled "USB".
7. Plug the 3-prong power cable into the power
jack on the side of the controller.
37
Advertisement
Table of Contents
