Component Specifications - 3M PROTECTA 2190057 User Instructions

;
Before using this equipment, record the product identification information from the ID label in the 'Inspection and
Maintenance Log' at the back of this manual.
System Specifications:
Capacity:
Anchorage:
Breaking Strength:
Maximum Deflection:
Service Temperature:
Standards:

Component Specifications:

Figure 2
Component
Reference
A D-Ring
B Web Loops
C Wear Sleeve
D Labels
Table 1 – Product Specifications
One person with a combined weight (including clothing, tools, etc.) of no more than 420 lb. (190
kg).
Anchorage structure requirements vary with the system application and whether it is a certified
anchorage or non-certified anchorage. The anchorage structure must sustain static loads applied
in the directions permitted by the anchorage connector.
System Application Certified Anchorage
Fall Arrest 2 times maximum
arresting force
Restraint 2 times foreseeable force
When more than one system is attached to an anchorage, the strengths stated above must be
multiplied by the number of systems attached to the anchorage. See ANSI Z359.2 for more
information.
;
Anchorage must be approved by a Qualified Person.
5,000 lbf (22.2 kN) Minimum Breaking Strength when loaded within the recommended working
range in parallel orientation with concrete face.
The maximum deflection for the anchorage connector and its anchorage connection point as a
result of fall arrest is 0 in. (0 mm).
-40°F to 130°F (-40°C to 54.4°C)
Each product model is certified to, or conforms with, the applicable standards and regulations listed
within Figure 1.
;
Product certified to ANSI/ASSP standards has been tested in compliance with the
requirements of ANSI/ASSP Z359.7.
Non-Certified Anchorage
5,000 lbf (22.2 kN)
1,000 lbf (4.4 kN) per ANSI
5,000 lbf (22.2 kN) per OSHA
Materials
Alloy steel
Polyester
Polyester
Polyester
4
Defined by
OSHA, ANSI
OSHA, ANSI