Component Specifications; Connector Specifications - 3M PROTECTA 3590500 User Instructions

;
Before using this equipment, record the product identification information from the ID label in the 'Inspection and
Maintenance Log' at the back of this manual.
System Specifications:
Anchorage: Anchorage structure requirements vary with the system application and whether it is a certified
anchorage or non-certified anchorage. The anchorage structure must sustain static loads applied in
the directions permitted by the Fall Protection system.
When more than one system is attached to an anchorage, the strengths stated above must be
multiplied by the number of systems attached to the anchorage. See ANSI Z359.2 for more
information.
Service Temperature: -40°F to 130°F (-40°C to 54.4°C)
Standards: Each product model is certified to, or conforms with, the applicable standards and regulations listed
within Figure 1. If none are specified, then all standards and regulations listed on the cover apply.

Component Specifications:

Figure 2
Component
Reference
A Lifeline
B Housing
C Bottom Connector
D Top Connector
E Swivel Eye
F Energy Absorber
G Rotation Handle
H Bracket
--- Drum
;
Internal Components: Internal SRD components are made from a combination of Stainless Steel, Steel, and Aluminum.

Connector Specifications:

Figure 1
Model Number
Reference
C1 2000112
C2 2000175
C3 2100044
;
Tensile Strength: The tensile strength of each of the connectors listed above is 22.2 kN (5,000 lbf).
Lifeline Specifications:
Figure 1
Description
Reference
GS1 7/32 in. (5.56 mm) galvanized steel wire rope
GS2 3/16 in. (4.76 mm) galvanized steel wire rope
SS1 3/16 in. (4.76 mm) stainless steel wire rope
Table 1 – Product Specifications
System Application Certified Anchorage
Fall Arrest 2 times maximum
arresting force
Restraint 2 times foreseeable force
Rescue 5 times applied load
;
Anchorage must be approved by a Qualified Person.
Description
Carabiner
Swivel self-locking snap hook
Swivel self-locking snap hook
Non-Certified Anchorage
5,000 lbf (22.2 kN)
1,000 lbf (4.4 kN) per ANSI
5,000 lbf (22.2 kN) per OSHA
3,000 lbf (13.3 kN)
Materials
(see Lifeline Specifications)
Aluminum
(see Connector Specifications)
(see Connector Specifications)
Steel
Rubber cover with polyester lifeline
Steel
Stainless steel
Aluminum
Material
Steel
Zinc-plated steel
Stainless steel
C1
5
Defined by
OSHA, ANSI
OSHA, ANSI
ANSI
Gate Opening Gate Strength
11/16 in. (17 mm) 3,600 lbf (16 kN)
3/4 in. (19 mm) 3,600 lbf (16 kN)
3/4 in. (19 mm) 3,600 lbf (16 kN)
C2 C3