Component Specifications; Connector Specifications - 3M DBI-SALA 1246518 User Manual

;
Before using this equipment, record the product identification information from the ID label in the 'Inspection and
Maintenance Log' at the back of this manual.
System Specifications:
Anchorage: Anchorage structure requirements vary with the system application and whether it is a certified
anchorage or non-certified anchorage. The anchorage structure must sustain static loads applied in
the directions permitted by the anchorage connector.
When more than one system is attached to an anchorage, the strengths stated above must be
multiplied by the number of systems attached to the anchorage. See ANSI Z359.2 for more
information.
Standards: Each product model is certified to, or conforms with, the applicable standards and regulations listed
within Figure 1. If none are specified, then all standards and regulations listed on the cover apply.

Component Specifications:

Figure 3
Component
Reference
A Anchoring Connector
B Harness Connector
C Energy Absorber

Connector Specifications:

Figure 1
Model Number
Reference
C1 9502116
C2 2000210
C3 2000209
C4 2000125
C5 9505254
C6 2000194
CL 9501538
;
Tensile Strength: The tensile strength of each of the connectors listed above is 22.2 kN (5,000 lbf).
C1 C2
Table 1 – Product Specifications
System Application Certified Anchorage
Fall Arrest 2 times maximum
arresting force
Restraint 2 times foreseeable force
Work Positioning 2 times foreseeable force
Rescue 5 times applied load
;
Anchorage must be approved by a Qualified Person.
Description
Snap hook
Rebar hook
Rebar hook
Rebar hook
Snap hook
Rebar hook
Choker loop
C3 C4 C5
Non-Certified Anchorage
5,000 lbf (22.2 kN)
1,000 lbf (4.4 kN) per ANSI
5,000 lbf (22.2 kN) per OSHA
3,000 lbf (13.3 kN)
3,000 lbf (13.3 kN)
Materials
(see Connector Specifications)
(see Connector Specifications)
Tear Web: Vectran polyester
Material
Zinc-plated steel alloy
Zinc-plated steel alloy
Aluminum alloy and zinc-plated
steel alloy
Zinc-plated steel alloy
Aluminum alloy and zinc-plated
steel alloy
Zinc-plated steel alloy
Kevlar nomex webbing
C6
4
Defined by
OSHA, ANSI
OSHA, ANSI
OSHA, ANSI
ANSI
Gate Opening Gate Strength
3/4 in. (19 mm) 3,600 lbf (16 kN)
2.5 in. (63.5 mm) 3,600 lbf (16 kN)
2.5 in. (63.5 mm) 3,600 lbf (16 kN)
3.0 in. (76.2 mm) 3,600 lbf (16 kN)
3/4 in. (19 mm) 3,600 lbf (16 kN)
4.3 in. (109 mm) 3,600 lbf (16 kN)
--- ---