Brother HL-3160CDW Service Manual page 46

Error message
First line
No Tray T1 Reinstall Tray 1
No Waste Install the Waste
Toner Toner Box.
Out of Press Go for 2
Memory seconds.
Print Data Full Print Data is full.
Press Cancel and
delete the
previously stored
data.
Print Unable Turn the power off
01 and then back on
again.
Print Unable Turn the power off
02 and then back on
again.
Print Unable Turn the power off
05 and then back on
again.
Second line
The T1 paper feed sensor
detected that the T1 is open
when printing from the T1
(before the registration of
printing in the engine).
The T1 paper feed sensor
detected that the T1 is open
when printing from the T1 (after
the registration of printing in the
engine).
The electrodes of the high-
voltage power supply PCB
detected that no waste toner
box was set.
The memory is insufficient to
expand the data of PC-Print.
The memory used to store
secure print data exceeded the
memory size for secure print
data.
ASIC error or motor driver error
occurred.
Cannot detect the synchronized
signal of the paper feed motor.
The speed of the paper feed
motor does not stabilize within
the specified time.
Cannot detect the synchronized
signal of the process motor. The
speed of the process motor
does not stabilize within the
specified time.
Detected the fuser unit
temperature error.
2-27
Description
Error Refer
codes to:
8501 2-70
8505 2-70
6300 2-64
C700 2-80
C800 2-80
0101 2-48
0201 2-48
0202 2-48
0501 2-49
0502 2-49
0503 2-49
0504 2-49
0505 2-49
0506 2-49
050A 2-50
050B 2-50
050C 2-50
Confidential