Brother HL-3160CDW Service Manual page 108

■
Paper jam at the paper feeding section at the center of the machine
<User Check>
• Check that the paper is set in the T1 correctly.
• Flip over the paper in the T1 or rotate the paper 180°.
• Adjust each paper guide according to the paper size.
• Check that there is not too much paper set in the T1.
• Check that the thickness of the paper is 60 to 163 g/m
• Flip through the paper and reset it in the T1.
• Check that the belt unit is installed correctly.
• Replace the drum unit.
• Replace the belt unit.
Step
Foreign object inside the
1
machine
2 Eject actuator coming off
Connection failure of the eject
3
sensor harness
4 Fuser cover attachment failure
5 Damaged fuser drive gear
6 Eject sensor failure
7 Registration rear sensor failure
Paper feed motor or process
8
motor failure
9 Damaged fuser unit
10 Main PCB failure
Cause
2-89
2
.
Remedy
Remove the foreign object.
Reattach the eject actuator.
Reconnect the eject sensor harness.
Reattach the fuser cover.
Replace the fuser drive gear.
Replace the eject sensor PCB.
Replace the paper feed unit.
Replace the process drive unit.
Replace the fuser unit.
Replace the main PCB.
Confidential