Scaleo medical Poweo 300 User Manual page 15

therefore a warning for the user: it means that the security device is operating, so the
transfer of the patient is not secured.
Battery management
The Poweo® 300 are equipped with a NiMh battery + Poweo® Power Pack charger, which contains
advanced safety features, including electronic protections against short circuits, over voltages and
over temperature. If one of these parameters exceeds the specified value, the battery will stop
working, preventing the user from overheating and the risk of fire.
When the LED indicator of the remote control turns red, it means that the battery needs to be
recharged. There is still enough power to perform at least one patient lowering.
When the battery discharge threshold is reached, the user is alerted by a beep. If the battery does
not recharge quickly, the display on the control box turns off and the up / down function will not
work.
The remote control have a three states battery LED: green, red, flashing red. Red LED means that
the battery needs to be recharged
Charging the battery
If the emergency stop button is pressed, the battery will not charge.
To charge the SCALEO® battery:
1. Connect the charger to the AC outlet,
2. Place the battery in the battery charger,
3. Once the battery is detected in the charger, the LED indicator lights up.
It will take 2h30 to 5 hours to recharge 100% empty batteries.
For intensive daily use a daily recharge will be necessary.
The batteries cannot be overcharged. However, to ensure better performance and longevity, it is
recommended to let them rest for a few minutes after charging and before use. It is also important
to fully charge the battery.
15 DOMU124_EN_v2_20221206_Poweo® 300 User manual