Table of Contents
Advertisement
prevent foreign substances and dirt in the
water from entering the washing machine.
Dirty filters must be cleaned.
1. Close the taps.
2. Remove the nuts from the water supply
hoses to access the filters on the water
supply valves. Clean the residue with a
suitable brush. If the filters are too dirty,
remove them with pliers and clean them
this way.
3. Remove the filters on the flat ends of the
water supply hoses with the gaskets and
clean them carefully under running water.
4. Install gaskets and filters carefully
back into place and twist off
the hose by hand
6.5 Clean remaining water
w and the pump filter
The filter system in your machine prevents
pieces such as buttons, coins and fabric
fibers from clogging the pump impeller
while pumping out the water. This way the
water will drain without any problems and
the life of the pump will be extended. If the
machine cannot pump out the water, the
pump filter is clogged.
The filter should be cleaned if it is clogged
or at least every 3 months. The water
must first be pumped out to clean the
pump filter.
In addition, before the machine is
transported (eg if you move house) and in
case of freezing of the water, the water
must be completely pumped out.
a
PAY ATTENTION!
• Foreign material left in the pump filter
can damage your product or cause
strange noises.
• When the product is not in use, close the
tap, remove the water supply hose and
drain the water from the machine to
prevent it from freezing.
• After each use, close the water tap to which
the water hose is connected.
40 / NL
1. In order to clean the full filter and pump out
the water, unplug the machine to turn off the
power.
a
PAY ATTENTION!
• Water temperature in the machine can
reach 90 ºC. To avoid the risk of burns,
clean the filter after the water in the
machine has cooled down.
2. Open the filter cover. Press the tab down
in the direction of the arrow and pull the
cover away from yourself.
3. Use it to pump out the water in
the machine.
a. Place a large shallow container in front of the
filter to collect the water from the filter.
b. Twist and loosen the pump filter until water
starts to run (counterclockwise). Direct the
running water into the container you placed in
front of the filter. Always keep a cloth handy to
absorb any spilled water.
c If the water comes out of the machine
pumped, remove the filter
completely by turning it.
4. Clean all debris in the filter as well as
fibers, if any, around the pump impeller.
5. Replace the filter.
6. Close the filter cover.
Washer Dryer / User Manual
Advertisement
Table of Contents
