Table of Contents
Advertisement
3 Installation
C
INFORMATION
• Your washing machine automatically
detects the amount of laundry
the machine is placed at the
selection of a program.
• During product installation, before first
use, the machine must be calibrated to
ensure that the amount of laundry is
detected as accurately as possible.
• To do this, select the Drum cleaning*
program and cancel the Spinning function.
Start the program without any laundry. Wait
until the end of the program. This takes
about 15 minutes.
*
The name of the program may vary
depending on the model. For
appropriate program selection,
please refer to the program
descriptions chapter.
To prepare the product for use, read the
information in the user manual and make
sure that the electricity, water connection and
drainage systems are suitable. If not, call a
licensed technician and plumber to have the
necessary work done.
B
DANGER!
• Make sure that the installation and
electrical connections of the product are
performed by qualified persons. The
manufacturer cannot be held liable for
damage caused by work performed by
unauthorized persons.
DANGER!
• Your product is too heavy for one
person to carry.
11 / NL
a
PAY ATTENTION!
• Visually check the product for defects
before installation. In that case, don't
install it. Damaged products can pose a
risk to your safety.
a
PRECAUTION!
• Site preparation and electrical,
water supply and
- drainage installations at the installation site
are the responsibility of the customer.
• Make sure that the water inlet and drain
hoses as well as the power cord are not
bent, pinched or squeezed when placing the
product in place after installation or
cleaning work.
3.1 Suitable installation location
• Place the product on a hard and flat floor.
Do not place it on deep-pile carpet or
similar surfaces.
• Do not place the product close to the
edge if the floor has steps. Place
the product is not on a platform.
• Do not place the product on top of
the power cord.
• Do not install the product in environments
where the temperature may drop below 0 ºC.
See Drying Warnings)
• It is recommended that you leave a
space on the sides of the machine to
reduce vibration and noise
• There should be no lockable, sliding, or
hinged door in the installation site of this
product that would prevent the loading
door from opening fully.
• Operate the product in a well-ventilated
and dust-free environment.
• Do not place heat sources such as hot plates,
irons, ovens, etc. on top of the washing machine
or use them on the product.
Washer Dryer / User Manual
Advertisement
Table of Contents
