Table of Contents
Advertisement
5.6 Temperature selection
When a new program is selected, the
temperature recommended for that
program will appear on the temperature
indicator. The recommended temperature
may not be the highest value that can be
selected for the particular program.
Press on the buttonAdjustment
Temperature to change the temperature.
C
INFORMATION
• Temperature Adjustment button only works
backwards. For example, if the display shows
40 °C, but you want to select 60 °C, you will
have to press the button a few times until you
reach 60 °C from 40 °C.
C
INFORMATION
• If you turn to the cold wash option and press
the Set Temperature button again, the
recommended maximum temperature for
the selected program will appear in the
display. To lower the temperature, press
the "Temperature Adjustment" button
again.
Finally, the Cold light will illuminate,
indicating a cold wash.
You can also change the temperature after
the wash cycle has started. You can set the
desired temperature after the washing
program has started. However, you must do
this before the heating step starts.
5.7 Spin speed
selection
When a new program is selected, it appears for
the selected
25 / NL
-
-
-
-
-
-
-
-
-
-
-
-
program recommended spin speed on
the Spin speed indicator.
C
INFORMATION
• The recommended spin speed may
not be the highest that can be
selected for the particular
programme.
Press on the buttonSet spin speedto
adjust the spin speed. The spin speed will
gradually decrease.
Then, depending on the product
model, "Rinse Hold" and "No Spin"
options appear on the screen.
C
INFORMATION
• Spin Speed Adjustment button only
works in reverse. For example, if the
display shows 800 rpm, but you want to
select 1000 rpm, then press the button a
few times until
you reach 1000 rpm from 800 rpm.
5.7.1 If you want to spin
your laundry after the
Rinse Hold function:
- Thespin speedSet up.
- Press on the buttonStart/Pause. The
program will resume. The machine will pump
out the water and spin the clothes. If you want
to drain the water without spinning at the end
of the program, you can use the No Spin
function.
C
INFORMATION
• In programs where Spin Speed
Adjustment is not allowed, the spin
speed setting will not change and
you will hear a warning.
You can also change the spin speed after the
wash cycle has started. At the end of the
wash cycle, you can press the spin speed
selector button to select a spin speed.
However, you must do this before the
centrifugation step begins.
Washer Dryer / User Manual
Advertisement
Table of Contents
