Table of Contents
Advertisement
a
PAY ATTENTION!
• Make sure the
correct mounting
of the product. A
laundry very dirty
of the washing process and
If there are any leaks,
tighten and remove the
retighten carefully after checking the seal.
Keep the taps of the product closed when
not in use to prevent water leakage.
3.5 Connecting to the drain
• Attach the end of the drain hose
directly to the water drain, sink
or bathtub.
a
PAY ATTENTION!
• Your floor will flood if the hose comes
out of its housing while draining
water. There is also a risk of burns
due to high
washing temperatures! To avoid such
situations and to ensure smooth water inlet
and outlet of the machine, fix the end of the
drain hose securely so that it cannot move.
13 / NL
2
2 Turn
from
hand
never
when
tired
3
3 Open the taps
completely after the
hose is connected
to control
whether there are water leaks
are on the
connection points.
the tap then
nut. Tighten the nut
• Close
the drain hose a an on
40 cm and maximum 90 cm height.
• If the hose is placed at floor level or close to
the ground (less than 40 cm height) and
later raised, water drainage will be more
difficult and the laundry may come out
very wet. Therefore, follow the heights
listed in the picture.
• To prevent dirty water from flowing back into
the machine and for easy drainage, do not
immerse the end of the hose in the dirty
water or put more than 15 cm into the drain.
If it is too long, shorten it.
• The end of the hose must not be bent,
it must not be stepped on and the
hose must not be pinched between
the drain and the machine.
• If the hose is too short, use it by adding an
original extension hose. The hose length
should not exceed 3.2 m. To avoid failure
due to water leaks, the connection between
the extension hose and the product drain
hose must be properly fitted with a suitable
clamp so that it does not come loose and
leak.
Washer Dryer / User Manual
90 cm
mini m eal
Advertisement
Table of Contents
