Table of Contents
Advertisement
1. Slide the Endwall Trellis Bars 3" into the Trellis Bar Joiner from each end
and secure with (4) #10 Self Tap in the pattern pictured above.
2. Continue the process until you make a bar longer than needed.
3. Cut down to desired length from the previous step with a metal saw. Be
sure to only cut the open side to adjust length for desired height.
4. Drill a 1/2" access hole on either end of the assembled bar ½" from each
end. Drill on the inside face of the bar through one wall of the bar but not
both. This will be the guide hole for attaching the bar to the hoop in the
next step.
Horizontal Bar Attachment
1. Clamp Horizontal Bar into place inside your house using your marks as a guide.
2. Secure the bar to vertical uprights with ⅜ x 3½" hex bolts by drilling holes
through the middle of the existing lock channel and vertical supports on the
outside of end wall. (Drilled and installed outside to inside)
3. Secure end of bar to the hoop with #10 Self Tap through the ½" access hole.
4. Repeat the entire process for the opposite side of the hoop house ensuring that
the two bars are installed at the same height.
Need Help?
contact@bootstrapfarmer.com
Page 47
www.bootstrapfarmer.com
Advertisement
Table of Contents
