Table of Contents
Advertisement
3. Using the hinge as a guide mark and drill guide holes in the door frame using the
⅛" bit. Each hinge should be placed 3 inches away from the closest horizontal
cross piece of the frame.
4. Attach all hinges to the frame using the #8 screws.
5. Using shims and clamps, place the door so that it has space to swing freely once
attached.
6. Attach all hinges using #8 self tapping screws. Drill guide holes for ease of
installation.
7. Completing door latch installation: These steps will be completed after you finish
installing the plastic.
a. Cut a small hole through the plastic over the 1 inch hole that you drilled
back in step 1.
b. Thread latch through hole and align plate horizontally.
c. Secure front and back latch mounting plates with #8 self tapping screws.
d. Mount door latch receiving plate with #8 self tap screws against the door
frame edge so that the latch lays flat. (For double doors this goes on the
other door.)
e. Guide plate can be used to limit latch mobility.
NOTE: Some hardware from the kit will not be used. These parts (guide plate, 3" bolts)
are included in case you will be customizing your door.
Need Help?
contact@bootstrapfarmer.com
Page 29
www.bootstrapfarmer.com
Advertisement
Table of Contents
