Bootstrap Farmer 14 Hoop House Instruction & Owner's Manual page 42

Installing End Wall Plastic
Once the top/ long sides are covered, and you have cut the excess plastic off of the
hoop at the lock channel you can begin endwall installation.
1. While making sure the "inside" label is facing the inside of the house, install
spring wire along your base board while keeping the plastic stretched left & right
2. Next, stretch the plastic up and work from the top of the hoop to one side. You
will keep pressure by pulling up and out. You will install this spring wire into the
same lock channel that you secured the top plastic into.
3. Now repeat for the other side.
4. Install spring wire to attach the plastic to the uprights.
5. Install spring wire into all door lock channels.
6. Cut the plastic 3-4 inches away from the lock channel along the hoop. The
remaining piece will be used to cover the other end wall.
7. Carefully cut the seam between door and door frame to allow access. Cut out
door access only AFTER all plastic is secured with spring wire in all vertical and
horizontal lock channels.
8. Follow instructions for door latch on page 26 and install over plastic.
9. Repeat steps 1-8 for the opposite end wall if you have doors on both ends.
Repeat steps 1-3 for an end wall with no door.
Need Help? contact@bootstrapfarmer.com
Page 42
www.bootstrapfarmer.com