Door Hanging And Latch Installation - Bootstrap Farmer 14 Hoop House Instruction & Owner's Manual

Door Hanging and Latch Installation

NOTE: YOU WILL DRILL THE HOLE FOR THE LATCH BEFORE HANGING THE
DOOR. THEN HANG THE DOORS AND ATTACH ALL LOCK CHANNEL. AFTER ALL
OF THE PLASTIC IS IN PLACE COVERING THE ENTIRE HOOP HOUSE, YOU WILL
COME BACK AND INSTALL LATCH.
Tools
● ¼" drill bit
● ⅛" drill bit
● 1" hole saw (included with hardware pack)
● 7/16" sockets or adjustable wrench (you will need two)
● ¼" driver for #8 self tap
● Shims
Parts
● Hinges (4 per door)
● Cane bolt (1 per door)
● Spring (1 per door)
● Latch (1 per frame)
● ¼" x 3" bolts
● Nuts
● Lock channel and spring wire bundle
1. With the door laying flat on a hard surface, drill a 1" hole 5" from the door edge
and right in the middle of the door frame center brace. (This is part of the door
latch but the rest of the door latch installation takes place after plastic
installation.)
2. Decide if you want the doors to swing towards the interior or exterior of the
house. If using a single door decide if you want it to open left or right.
Need Help? contact@bootstrapfarmer.com
Page 28
www.bootstrapfarmer.com