Table of Contents
Advertisement
End Wall Lock Channel
For the hoops
On the end walls, install the lock channel from baseboard to baseboard going over the
outside/top of the hoop.
The channel will bend with the curve of the hoop with ZERO modifications, Do Not
Notch the Channel.
Keep your clamps at the ready to assist with bending and holding the channel as you
use the #8 self tap screws directly in the center of the channel. (Use the grooves in the
Lock Channel to keep your screws centered)
At the hip brace, cut off the lock channel and continue on the other side of the hip brace
to the bottom base brace on both sides.
For the end wall uprights
Attach the lock channel to all vertical end wall supports from the base brace up to 12"
below the top of your hoops.
Need Help?
contact@bootstrapfarmer.com
www.bootstrapfarmer.com
Page 25
Advertisement
Table of Contents
