Table of Contents
Advertisement
Dolphin Wave 200XL and 300XL Pool Troubleshooting Guide
3
Robot Doesn't Drive in Straight Lines
➣ In this chapter...
Robot in Shape Mode
Starting Point from a Shaped Wall
Deviation Greater Than 10° Degrees
3.1
Robot in Shape Mode
If possible, change the scanning mode to "Rectangular".
3.2
Starting Point from a Shaped Wall
Make sure the starting point is always from a straight wall and flat floor.
Important: The third line wall should also be straight.
3.3
Deviation Greater Than 10° Degrees
If, within 20 minutes from the start of scanning, the deviation is greater
than 10° degrees after a few lines, replace the Navigation box (see wave
200XL
Link
Deviation Greater Than 10 Degrees
and/or Video).
page 3
page 3
page 3
3
Advertisement
Table of Contents
