Table of Contents
Advertisement
Dolphin Wave 200XL and 300XL Pool Troubleshooting Guide
With regard to ...
Robot doesn't complete lines
Robot drives width (instead of
length)
Robot stays at wall
Robot stops before end of cycle
Sand in pool
Slippery pool floor
Starting from a shaped wall
Tunnels in pool
Unclean spots in pool
Worn vacuum strips
Note: Where relevant, external links point to detailed instructions on the
replacement or checking of specific parts beyond the scope of this
document.
2
Robot Works Along Walls for a Long
period of Time
➣ In this chapter...
Slippery Pool Surface
2.1
Slippery Pool Surface
Check if the chemicals in the pool are balanced.
1
Change the pool length settings to the width of the pool. For
2
example, if the pool size is 25x15, change it to 15m instead of 25m
and change the scanning mode to "Lines to" (see changing pool
length Video).
Slippery Pool Surface
See ...
Chapter 1 2, Robot Drives Back
before Capitalize the Line,
page 10
Chapter 6 , Robot Doesn't Climb
Slope, page 5
Chapter 2 , Robot Works Along
Walls for a Long period of Time,
page 2
Chapter 1 1, Robot Stops before
End of Cycle, page 9
Chapter 8 , Robot Doesn't Pick Up
Dirt, page 7
Chapter 9 , Robot Stays in the
Deep Area, page 8
Chapter 7 , Robot Leaves Unclean
Spots in the Pool, page 6
Chapter 7 , Robot Leaves Unclean
Spots in the Pool, page 6
Chapter 7 , Robot Leaves Unclean
Spots in the Pool, page 6
Chapter 8 , Robot Doesn't Pick Up
Dirt, page 7
page 2
2
Advertisement
Table of Contents
