Blocked Filter; Slippery Pool Floor; Floating Cable Gets Stuck Between Swimming Lanes Floats; Gaps Between Floats - Maytronics Dolphin Wave 200XL Troubleshooting Manual

Table of Contents

Advertisement

Dolphin Wave 200XL and 300XL Pool Troubleshooting Guide
9.2

Blocked Filter

Clean the filter (see wave 200XL filter cleaning
filter cleaning Video).
9.3

Slippery Pool Floor

Check if the chemicals in the pool are balanced.
10
Floating Cable Gets Stuck between
Swimming Lanes Floats
➣ In this chapter...

Gaps between Floats

10.1
Gaps between Floats
Place the floats closer to one side and make sure there are no gaps
1
between the floats.
Take out the swimming lines before operating the robot.
2
11

Robot Stops before End of Cycle

➣ In this chapter...

Robot in "Lines to" Mode

Alert LED On
Robot in "Lines to" Mode
11.1
There is no problem. The robot is supposed to stop cleaning the pool
when it reaches the wall at the other side of the pool.
Robot in "Lines to" Mode
Video
or wave 300XL
page 9
page 9
page 10
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dolphin wave 300xl

Table of Contents