Table of Contents
Advertisement
1
Overview
This Dolphin Wave 200 and 300 Pool Troubleshooting Guide is intended
to guide technician in addressing problems associated with possible faults
in the robot.
The information in this guide is organized according to type of
problem/symptom/component and the troubleshooting checks to be
performed to pinpoint the source of the problem.
With regard to ...
Alert ID is on
Communication with remote
Driving system failure
Filter blockage
Floating cable stuck between
floats
Leaves in pool
Lines are too close together
Lines are too far apart
Maze areas in pool
Niches in pool
Not climbing slope
Not driving in straight lines
Pool length
Remote ID
Overview
See ...
Chapter 1 1, Robot Stops before
End of Cycle, page 9
Chapter 1 3, Robot Not
Communicating with the Remote
Control, page 11
Chapter 1 2, Robot Drives Back
before Capitalize the Line,
page 10
Chapter 8 , Robot Doesn't Pick Up
Dirt, page 7
Chapter 9 , Robot Stays in the
Deep Area, page 8
Chapter 1 0, Floating Cable Gets
Stuck between Swimming Lanes
Floats, page 9
Chapter 8 , Robot Doesn't Pick Up
Dirt, page 7
Chapter 4 , Not Enough Space
between Lines, page 4
Chapter 5 , Too Much Space
between Lines, page 4
Chapter 7 , Robot Leaves Unclean
Spots in the Pool, page 6
Chapter 7 , Robot Leaves Unclean
Spots in the Pool, page 6
Chapter 6 , Robot Doesn't Climb
Slope, page 5
Chapter 3 , Robot Doesn't Drive in
Straight Lines, page 3
Chapter 1 2, Robot Drives Back
before Capitalize the Line,
page 10
Chapter 1 3, Robot Not
Communicating with the Remote
Control, page 11
1
Advertisement
Table of Contents
