Elo TouchSystems ET17 XXL Series Service Manual page 34

You must have already completed Steps 1 and 2 before proceeding. Refer to Chapter 2 of
the Elo DOS and Windows Driver Guide as necessary for additional installation information.
To run the INSTALL program:
• Type INSTALL at the DOS prompt in the directory containing the driver install files.
• INSTALL asks you to select the software to install. Then choose d:\EloDos_W31 from the
displayed list.
• INSTALL also asks you for the paths to use during installation, or you may use its defaults.
INSTALL creates directories as necessary, and warns you if they exist.
If you are updating your software, you may wish to specify the paths containing the earlier
versions, and overwrite the obsolete files. All executable programs are upward compatible.
For a list of differences from each previous version of the drivers, be sure to select
"Differences from Previous Versions" during the installation process.
INSTALL updates your AUTOEXEC.BAT file with the drivers you select.
INSTALL makes a copy of your original AUTOEXEC.BAT file, called
AUTOEXEC.OLD. If you already have Elo driver commands in your
AUTOEXEC.BAT file, they will be commented out.
When INSTALL is finished, it leaves a file called GO.BAT in the subdirectory you specified.
GO loads the touchscreen driver, runs the calibration program ELOCALIB, and gives you
some final instructions.
If you are using Windows 3.1, you will also calibrate the touchscreen within Windows 3.1
with the Touchscreen Control Panel.
Installing the USB Touch Driver
Installing the USB Touch Driver for Windows XP, Windows 2000, Me and 98
• Insert the Elo CD-ROM in your computer's CD-ROM drive.
If Windows 98, Windows Me or Windows 2000 starts the Add New Hardware
Wizard:
• Choose Next. Select "Search for the best driver for your device (Recommended)" and
choose Next.
• When a list of search locations is displayed, place a checkmark on "Specify a location" and
use Browse to select the \EloUSB directory on the Elo CD-ROM.
• Choose Next. Once the Elo TouchSystems USB touchscreen driver has been detected,
choose Next again.
• You will see several files being copied. Insert your Windows 98 CD if prompted. Choose
Finish.
If Windows 98, Windows Me or Windows 2000 does not start the Add New Hardware
Wizard:
NOTE:For Windows 2000 you must have administrator access rights to install the driver.
• Insert the Elo CD-ROM in your computer's CD-ROM drive.
If the AutoStart feature for your CD-ROM drive is active, the system automatically detects
the CD and starts the setup program.
• Follow the directions on the screen to complete the driver setup for your version of
Windows.
- -
31