Elo TouchSystems ET17 XXL Series Service Manual page 31

Depending on where you live, you will use either the European or US/Canadian power cable.
• Connect the female end of the power cable to the Brick power supply.
• Connect the Brick power cable into the power port on the touchmonitor.
• Route the cable through the cable management channel.
NOTE: To protect your equipment against risk of damage from electrical surges in the
power line, plug the touchmonitor's power cord into a surge protector, and then connect
the surge protector to a grounded AC electrical outlet.
6.Optimizing the LCD Display
To ensure the LCD display works well with your computer, configure the display mode of
your graphic card to make it less than or equal to 1280 x 1024 resolution, and make sure
the timing of the display mode is compatible with the LCD display. Refer to Appendix A
for more information about resolution. Compatible video modes for your touchmonitor are
listed in Appendix C.
7.VESA Mount on Your Touchmonitor
Your touchmonitor conforms to the VESA Flat Panel Monitor Physical
Mounting Interface (FPMPMI.) Standard which defines a physical mounting interface for
flat panel monitors, and corresponding standards for flat panel monitor mounting devices,
such as wall and table arms. The VESA mounting interface is located on the back of your
touchmonitor and is shipped pre-connected to the base.
To use the VESA mount, unscrew the rear U bracket, then mount to either 75mm or
100mm VESA mount. Use M4x.7 machine screws. Do not penitrate the screw into the
monitor more than 10mm.
- -
28