Elo TouchSystems ET17 XXL Series Service Manual page 21

Rear View
Bottom View (1747L shown)
3.Attaching the L-Brackets
Depending on your mounting scheme, use the L-brackets or the VESA 75/100mm
standard holes located on the back of the kiosk monitor or the 5.5 diameter holes (only on
rear mount). See page 15 for VESA mounting information.
NOTE: You will need a screwdriver to attach the L-brackets.
Your kiosk touchmonitor comes with a mounting bracket (C-bracket) attached at the back.
Included are two L-brackets (and four screws) that attach to both ends of the C-bracket
for additional mounting options.
To attach the L-brackets:
3-1 Lay the monitor face down.
3-2 Place the long end of the L-bracket against the end of the mounting
C-bracket. Line up the two holes of the L-bracket with the two holes of the
C-bracket. See the illustration below.
- 18 -