Elo TouchSystems ET17 XXL Series Service Manual page 18

STEP 5-Connecting the Power Cable
CONNECTIONS ON UNDERSIDE
POWER
Depending on where you live, you will use either the European or US/Canadian power cable.
• Connect the female end of the power cable to the Brick power supply.
• Connect the Brick power cable into the power port on the touchmonitor.
• Route the cable through the cable management channel.
NOTE:To protect your equipment against risk of damage from electrical surges in the
power line, plug the touchmonitor's power cord into a surge protector, and then
connect the surge protector to a grounded AC electrical outlet.
4.Optimizing the LCD Display
To ensure the LCD display works well with your computer, configure the display mode of
your graphic card to make it less than or equal to 1280 x 1024 resolution, and make sure
the timing of the display mode is compatible with theLCD display. Refer to page 38 for
more information about resolution.
Compatible video modes for your touchmonitor are listed in page 40.
5.VESA Mount on Your Touchmonitor
Your touchmonitor conforms to the VESA Flat Panel Monitor Physical Mounting Interface
(FPMPMI™) Standard which defines a physical mounting interface for flat panel monitors,
and corresponding standards for flat panel monitor mounting devices, such as wall and
table arms. The VESA mounting interface is located on the back of your touchmonitor and
is shipped pre-connected to the base.
You can also use the existing stand for wall mounting. For mounting dimensions, go to
www.elotouch.com/products/displcds.asp and under Model, click on Elo Entuitive
1725L/1727L. Click on drawing MS500231.
POWER CABLE
- 15 -
BRICK POWER SUPPLY